Binder CB 160 - Setting the Safety Controller

CB (E6.1) 07/2017 Page 88/145
14.2.2 Setting the safety controller
To display and to change the current safety controller settings in the “safety controller” submenu, go to
Menu > Safety controller
Safety controller mode: selection between Limit (absolute) and Offset (relative)
Fixed value
08.03.2013 05:05:06
Submenu “Safety controller”
Select “Mode”
and press the operating button.
..\ Safety controller
Mode
Setpoint
Show settings
Close Home
Fixed value
08.03.2013 05:05:06
Submenu “Safety controller mode”.
The current safety controller mode is displayed:
“Limit (absolute)” or “Offset (relative)”
To change the mode, press the operating button.
The modified safety controller mode is displayed.
..\ Safety controller mode
Limit (absolute)
Close Home
When changing the safety controller mode, the safety controller setpoint which had been active
before in this mode becomes active again.
Entering the safety controller setpoint
Fixed value
08.03.2013 05:05:06
Submenu “Safety controller”
Select “Setpoint”
and press the operating button.
..\ Safety controller
Mode
Setpoint
Show settings
Close Home
You can also access this submenu to directly enter the safety controller setpoint via
Quick menu > Safety controller setpoint