What does the alarm message - - - - or -> mean on my Binder vdl 23 Oven?
If your Binder oven displays the alarm message - - - -, , it indicates a sensor rupture between the sensor and controller or a defective Pt 100 sensor. Contact BINDER service.
Why am I getting a pressure alarm on my Binder oven when operating without a vacuum connection?
If you're getting a pressure alarm when operating your Binder oven without a vacuum connection, it's likely because the pressure control is turned on. Turn off pressure control.
What to do if acknowledging the alarm does not cancel the alarm state in my Binder oven?
If acknowledging the alarm does not cancel the alarm state in your Binder oven, it indicates that the cause of the alarm persists. Remove the cause of the alarm. If the alarm state continues, contact BINDER service.
What causes deviations from the temperature set-point in the equilibrated state of my Binder vdl 23?
If you notice deviations from the temperature set-point in the equilibrated state of your Binder oven, it could be due to invalid calibration. Use only the delivered expansion racks and do NOT change between aluminum and stainless steel racks.
Why are there deviations from the indicated heating-up times in my Binder vdl 23?
If you're experiencing deviations from the indicated heating-up times in your Binder oven, it might be because the oven is fully loaded. Try charging the oven with less material or consider allowing longer heating-up times.
Why am I measuring the wrong temperature value during Binder vdl 23 calibration?
If you are measuring the wrong temperature value during calibration of your Binder oven, it could be due to: * Insufficient contact between the reference temperature sensor and the expansion rack. Fix the reference temperature sensor with thermal conductive paste or adhesive aluminum tape. * Leakage current when using a thermo element that is not electrically isolated. Mount a thermo element electrically isolated from the rack.
What to do if Binder oven controller does not equilibrate to entered setpoints?
If the controller of your Binder oven does not equilibrate to entered setpoints, make sure that: * Temperature control is turned on. * Pressure control is turned on.
Why is the Binder vdl 23 Oven vacuum not being held?
If the vacuum in your Binder oven is not being held, check the following: * The door gasket might be defective. Replace it. * The safety glass panel might be defective. Replace it. * The gaskets of small flange connections (universal eccentric ring) might be defective. Replace them. * The inner tube connection might be leaky. Contact BINDER Service.
How to troubleshoot a Binder vdl 23 Oven chamber that is permanently turned off?
If your Binder oven chamber is permanently turned off, check the following: * Ensure there is a power supply connection. * Verify the power supply voltage matches the oven's requirements (115V or 230V). * Check the chamber fuse. * If none of these resolve the issue, the controller may be defective. Contact BINDER Service.
Why is my Binder vdl 23 Oven chamber heating permanently and not maintaining the set-point?
If your Binder oven chamber is heating permanently and not maintaining the set-point, it could be due to several reasons: * The controller might be defective. Contact BINDER service. * The Pt 100 sensor might be defective. * The semiconductor relay might be defective. * The controller might not be adjusted. Calibrate and adjust the controller.
General| Model | VDL 23 |
|---|---|
| Manufacturer | Binder |
| Voltage | 230 V |
| Frequency | 50/60 Hz |
| Number of Shelves (standard/max) | 2 / 3 |
| Category | Oven |
| Safety Features | Overheat protection |
To Next Page
