Installation
Instruction manual NSF VSI / VSI W / VSI T / VSI
TW
28 / 101 38065447002 en-US
Measures for suppressing interference:
With severely contaminated mains supplies (e.g. when "thyristor-controlled systems" are
used) measures must be taken on-site to suppress interferences, e.g.:
– A separate supply line must be planned for Bizerba machines
– In problem cases, install capacitive decoupled isolating transformers or other suppressors
into the supply mains prior to Bizerba machines
4.4 Start-up
Initial start-up as well as instructions on how to operate, clean, maintain and service the ma-
chine are initially provided by the responsible Bizerba service department.
4.4.1 Switching the slicer on
On the display and operating unit press
the <ON switch>.
White lamp lights up, supply voltage is
applied.
The display becomes active.
Fig.9: ON/OFF switch
Machine carries out a system check. On the
information bar the required steps are listed.
Successfully completed steps receive a
check mark.
Press <Execute> on the display and op-
erating unit after initialization.
Machine moves to zero position.
The individually configured operator
page (main page) is loaded.
Machine comes to a standstill if not all check
marks could be set.
Switch off machine, wait 5 seconds and
switch machine back on again.
Fig.10: Home page
4.4.2 Switching the machine off
Press red key <O>. (reduced operating force)
The machine is switched off.
To Next Page
Loading...
Need help?
General
