Maintenance
Instruction manual NSF VSI / VSI W / VSI T / VSI
TW
86 / 101 38065447002 en-US
When necessary, clean or exchange the grinding discs. Caution. Please, note! Left-
handed thread!
At an annular gap of more than 6mm between blade and blade guard, the
sharpener no longer has a sharpening effect and the blade has to be re-
placed by the Bizerba Service.
WARNING
Changing the blade!
Severe injuries and damage to property.
– For safety reasons, the blade may only be changed by Bizerba cus-
tomer service.
– Wear cut-proof gloves and shoes with toe caps.
8.6.1 Blade sharpening
Re-sharpening of the blade is necessary if the slicing result is unsatisfactory.
The time intervals are dependent on the wear and tear of the blade and its operating usage
as also the properties and conditions of the product.
Sharpener
The sharpener identified by the machine number has been adjusted for this machine.
The device is fitted with a coarse sharpening stone and a finely grained honing stone. Dirty or
greasy sharpening stones do not sharpen well.
Before sharpening, clean with brush and solving detergent.
If sharpening stones are worn, replace stones.
Replacement parts are supplied by Bizerba customer services.
When replacing, do not confuse sharpening and honing stones.
Preparation for sharpening
WARNING
Unprotected blade!
Coming in contact with the sharp blade can lead to serious injuries.
– Wear cut-proof gloves when cleaning and sharpening.
– Do not clean the blades when operating the machine.
- The machine is cleaned. The blade is clean.
- The machine is switched on.
- The main page comes up on the touch screen.
To Next Page
Loading...
Need help?
General
