Operation
Instruction manual NSF VSI / VSI W / VSI T / VSI
TW
56 / 101 38065447002 en-US
The first cut icon flashes in the status bar:
– before and during first cut slicing
– after resetting the portions counter to zero
– to show that the first cut is done after product change and again after restart.
First cut discharge function
This function is available for devices with conveyor belt.
It is always active when the function first cut is active.
The first cut slices are transported. It can be selected if the first cut is to be transported for-
wards or backwards.
6.10 Slicing product
WARNING
Rotating blade!
Cut injuries
– Do not allow yourself to become distracted. Concentrate on the task in
hand and avoid time pressure.
– During operation, do not reach into the path of the carriage.
– Never push product ends towards blade by hand.
WARNING
Moving components!
Risk of entanglement, shearing, crushing and being hit.
– Do not wear loose clothing or wear hair down.
– Do not reach into paths of carriage, product holder, gauge plate, de-
positing system, conveyor and depositing table.
– Only clean machine when switched off and power plug is pulled.
- Product is loaded and fastened by means of product holder and product fixation device.
- Machine is switched on. The slicing program used last is shown on the touch screen.
To Next Page
Loading...
Need help?
General
