Instruction manual NSF VSI / VSI W / VSI T / VSI
TW Machine and operating elements
38065447002 en-US 45 / 101
Removing of deposited portions and paper:
Using your thumb, press lever slightly to the right; at the same time pull top-most piece of
paper with portion under the open holders.
Release lever.
5.4 Product fixation device
The properly applied product fixation device holds the product in position during slicing pre-
venting the product from deflecting and tipping over.
Product fixation device, vertical (carriage
400mm and 600mm)
The product fixation device is guided on a
shaft and can be moved across the full width
of the carriage. This way, it can be posi-
tioned on any product size.
Fig.22: Product fixation device, vertical
To Next Page
Loading...
