Machine and operating elements
Instruction manual NSF VSI / VSI W / VSI T / VSI
TW
38 / 101 38065447002 en-US
If the anchor is set to the number of slices, it will be set back automatically for the slice thick-
ness and vice versa.
The number of slices is fixed.
In order to obtain the preset portion weight,
the slice thickness is changed during slicing.
The slicing of the preset number of slices is
carried out. Enter at least 4 slices for opti-
mum weight control.
Portions can be cut precisely in accordance
with the target weight with this technique.
If the anchor is set to the number of slices,
then the slice thickness can not be changed.
The numeric input field and the up-/ down
keys are grayed out and disabled for opera-
tor entry.
The slices vary in thickness.
Fig.12: Anchor set to number of slices
The slice thickness is fixed.
As many slices are cut as required to reach
or exceed the target weight.
The slice thickness does not change which
means that all slices are of equal thickness.
Less accurate procedure.
If the anchor is set to the slice thickness,
then the number of slices can not be
changed. The numeric input field and the
up-/ down keys are grayed out and disabled
for operator entry.
Fig.13: Anchor set to slice thickness
Shingling length is fixed.
In order to obtain the preset shingling length,
the shingling distance is reduced or in-
creased.
If the anchor is set to shingling length, the
shingling distance can not be changed. The
numeric input field and the up-/ down keys
are grayed out and disabled for operator en-
try.
Fig.14: Anchor is set to shingling length
To Next Page
Loading...
Need help?
General
