49
Emergency stop button (1)
The emergency stop button is a pushbutton for emergency shutdown of the
machine. Before restarting the machine, the cause that led to the emergency
stop must first be eliminated. Then the emergency stop button must be
unlocked by turning and simultaneously pulling it out. See also Section 2.9.1.
Start/stop button motor (2)
Switches the diesel motor on/off. To start the diesel motor, press the motor
start/stop button until the diesel motor is running. To stop the motor, press
the motor start/stop button again.
On/off button delivery (3)
Activates/deactivates the automatic conveyor.
Compressor pressure gauge (4)
The compressor pressure is displayed on the pressure gauge (4). This
pressure display can be used to monitor the delivery process. Possible
blockages can be recognised when the compressor pressure drops.
Boiler pressure gauge (5)
The pressure in the mixing and delivery vessel is displayed on the pressure
gauge (5). The quantity of upper and lower air can be adjusted with the lever
(10) and (11) only when the vessel pressure is sufficient.
➢ When the lower air is open, the delivery pressure shown on the
pressure gauge corresponds to the vessel pressure.
On/Off switch mixing unit (6)
This is a two-position switch. It switches the mixing unit in the mixing and
delivery vessel on/off.
Multifunction display (7)
Via the multifunctional display, e.g. fill levels are monitored and fault and
warning messages are issued. It is also possible to switch over to manual
mode. For more information on the controls on the multifunction display, see
Section 4.6.2. For information on the individual menus, see Section 4.7.
To Next Page
Loading...