2.4 Residual risks
Residual risks are special hazards involved in handling of the frequency inverter which cannot be elim-
inated despite the safety-compliant design of the device. Remaining hazards are not obvious and can
be a source of possible injury or health damage.
Typical residual hazards include:
Electrical hazard
Danger of contact with energized components due to a defect, opened covers or enclosures or im-
proper working on electrical equipment.
Danger of contact with energized components in frequency inverter if no external disconnection de-
vice was installed by the operator.
Electrostatic charging
Touching electronic components bears the risk of electrostatic discharges.
Thermal hazards
Risk of accidents by hot machine/plant surfaces, e.g. heat sink, transformer, fuse or sine filter.
Charged capacitors in DC link
The DC link may have dangerous voltage levels even up to three minutes after shutdown.
Danger of equipment falling down/over, e.g. during transport
Center of gravity is not the middle of the electric cabinet modules.
2.5 Safety and warning signs on the frequency inverter
Comply with all safety instructions and danger information provided on the frequency inverter.
• Safety information and warnings on the frequency inverter must not be removed.
10/13
ACU
Modbus/TCP 9
To Next Page
Loading...
Need help?
General
