Bosch Solution 16i Installation Manual

4-4
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Programming Overview
G ET TI N G STAR T ED BAC K TO BA SE
The following steps are the mimimum requirements to
get the system reporting back to base. Examples assume
the panel is disarmed with no alarms and starting from
factory default settings.
1) Enter Program mode.
[1234 + MENU]
2) Set Time and Date.
[MENU 7-1-0]
3) Change Default Installer PIN.
[MENU 1-5-2]
4) Change Default Master PIN.
[MENU 1-1-1]
5) Enter Account (client) Number, Area 1.
[MENU 2-2-0]
6) Enter Base Primary Telephone Number.
[MENU 5-1-1]
7) Enter Base Secondary Telephone Number.
[MENU 5-1-2]
8) Hold Down MENU Key To Exit.
S ER VI CE MO DE
Service mode when activated disables dialler reporting,
prevents all alarms and prevents all users from arming the
system.
To Turn Service Mode ON
1) Enter Program Mode.
[1234 + MENU]
2) Enter,
[MENU 7-0-8]
3) The display will show IS OFF if service mode is o or
IS ON if service mode is on.
4) Press the On or OFF key to change the service
mode state then press [OK] to exit.
SERVic
i
Note
Keypads will display SErVIC on the screen when
service mode is active.
D EFAU LT I NG THE SYS T EM
Defaulting the system will reset all programming options
back to the factory default setting. All programming
information will be erased.
To Hardware Default
1) Remove All Power To The System. AC and
Battery.
2) Press and Hold The Default Push Button
Down Then Apply Power To The System.
3) Release Button, The Panel Will Reset And
Revert To Normal Operation When Default Is
Complete.
To Software Default
1) Enter Program Mode.
[1234 +MENU]
2) Select Factory Default Option.
[MENU 7-0-4)
3) The Panel Will Reset And Revert To Normal
Operation When Defaulting Is Complete.
FDEF ?
Figure 37: Factory Default Display
i
Note
You can disable factory defaulting using MENU 7-7-
4. If factory defaulting has been disabled you must
know the installer code to perform a factory default
otherwise the system will need to be returned to your
supplier for defaulting or you can purchase a CM255
Default Unlock Key which will unlock the panel in the
eld. Charges apply for defaulting if retuned to the
distributor.
D OM ES TI C T EMP LAT E DE FAU LT S
The following table list the changes that will occur when
you select domestic default.
Program Option Domestic Default Value
All Trouble Reports Disabled
All Bypass Reports Disabled
All Restore Reports Disabled
Destination 1 TX Format Domestic Reporting
Open / Close Reports Disabled (all areas)
System Events Route Log Only
Table 17: Domestic Dialing Defaults Settings

Bosch Solution 16i Specifications

General

Brand	Bosch
Model	Solution 16i
Category	Security System
Language	English