4-12
Bosch Security Systems 09/11 BLCC500I
Solution 16i
Installation Manual Programming Overview
5 Comms (Con’t) 6 Devices 7 System
5-5 MyAlarm 6-0 Commands 7-0 Commands
5-5-0 IP Address UMI 6-0-0 LAN Status
UMI 7-0-0 Panel Status
5-5-1 Port # I 6-0-1 LAN Secure UMI 7-0-1 System Trouble
5-5-2 Options UMI 7-0-2 History Log
5-5-3 Reserved 6-1 Keypads I 7-0-3 Domestic Default
5-5-4 Reserved MI 6-1-0 Volume I 7-0-4 Factory Default
5-5-5 Reserved MI 6-1-1 Contrast
I 7-0-5 Template Default
5-5-6 Reserved MI 6-1-2 Backlight I 7-0-8 Service Mode
5-5-7 Reserved I 6-1-3 Home Area
MI 5-5-8 Email Address I 6-1-4 General Options 7-1 Clock
MI 5-5-9 Email Options I 6-1-5 Beeper Options MI 7-1-0 Set Date & Time
I 6-1-6 Emergency Keys I 7-1-1 Summertime On
5-6 IP I 6-1-7 Access Group
I 7-1-2 Summertime O
I 5-6-0 Base Station IP I 6-1-8 Lockout Time
I 5-6-1 Base Station Port
7-2 Timers
I 5-6-2 Poll Rate 6-2 RF Devices I 7-2-0 Exit Time
I 5-6-3 Ack Wait Time I 6-2-0 Receiver Options I 7-2-1 Entry Time 1
I 5-6-4 IP Format I 6-2-1 Supervision Time I 7-2-2 Entry Time 2
I 5-6-5 Retry Count I 6-2-2 RF Device Options
I 7-2-3 Part Entry Time
I 5-6-6 RAS IP Address I 6-2-3 Add RF Keypad I 7-2-4 Auto Arm Pre Alert
I 5-6-7 RAS IP Port I 6-2-4 Delete RF Keypad
I 7-2-5 Output Pre Alert
I 5-6-8 IP RAS Options I 6-2-5 View RF Device ID I 7-2-6 Senior Watch Time
I 5-6-9 RAS IP Lockout
6-3 Serial Device
7-3 Power
5-9 Comms Test I 6-3-0 Device Type I 7-3-0 AC Options
UMI 5-9-0 Send Test Report I 6-3-1 Baud Rate I 7-3-1 Battery Options
I 5-9-1 Test Report Time I 6-3-2 Flow Control I 7-3-2 Fuse Options
I 5-9-2 Test Report Period
I 5-9-3 Test Report Options 6-5 GSM Modem 7-4 Siren
I 5-9-4 Test Route I 7-4-0 Tone
I 5-9-5 Dial Number Test
6-6 Ethernet
I 7-4-1 Speed
I 6-6-0 IP Address Module I 7-4-2 Volume
I 6-6-1 Subnet Mask I 7-4-3 Swinger Siren
I 6-6-2 Default Gateway
I 6-6-3 MAC Address
7-5 Schedules (TEF)
I 6-6-4 Encryption Key MI 7-5-0 Name
I 6-6-5 IPRS (Reserved)
MI 7-5-1 Time
I 6-6-6 IPRS Port (Reserved) MI 7-5-2 Day
I 6-6-7 Connetix NCC I 7-5-3 Function
I 6-6-8 Reserved I 7-5-4 Index
I 6-6-9 Ethernet Options
7-6 Holidays
6-7 Access Controller
MI 7-6-0 Name
MI 7-6-1 Start Stop Dates
6-8 X10 Device
7-7 System Options
I 7-7-0 General Options
I 7-7-1 Area Options
I 7-7-2 Keypad Idle Screen
MI 7-7-3 Keypad Hi/Lo Temp
I 7-7-4 Installer Options
I 7-7-5 Language
MI 7-7-7 Site Name
7-9 System Testing
UMI 7-9-0 Walk Test All Zones
UMI 7-9-1 Battery Test
Table 21: Programming Locations and Descriptions
To Next Page
Loading...
