Bosch Solution 16i Installation Manual

5-2
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Access Programming
Example:
Prox reader operating door and arm/disarm Area 1.
1) Assign proximity reader 1 to an access group 1-8
say 4
2) Set an output Event type=Access group and
Index=4
3) Assign user to access group 4, a user can belong to
multiple access groups to access multiple doors.
4) Assign reader to area 1, enable arming/disarming
and Badging option.
2) Present token to disarm, present token to release
door, present token 3 times to arm system.
U SE R D E FAU LT TA BL E
Parameter User 1 User 2 - 48
Add PIN 2580
Name User 1 User 2 - 48
Area Assignment 1 1
User Options
Has Master PIN Privileges Y
Expire PIN Code
Is Arm Only Code
Can Bypass Zones Y Y
Can Auto Bypass Zones Y Y
Send ‘Open/Close’ Reports Y Y
Timer Group
Access Group
Table 22: User Default Programming Options
U SE R P I N CO DES
At factory default, each PIN is set to 4 digits in length.
The default PIN for User 1 (Master user) is 2580. Only the
Installer can change the PIN Length see MENU 1-5-0 —
PIN Length.
Access > PIN Codes >
dEL-Ur
Erase User

-

MENU 1-0-0
This command allows a master user or installer to to erase
another user from the system. Erasing a user will remove
the user’s PIN, Proximity Token and RF keyfob credentials.
1) Enter your Installer PIN or Master PIN + [MENU]
2) Enter [1] + [0] + [0] + [OK].
The keypad will display Ur = prompting you to enter
the number of the user to erase.
Ur=
3) Enter the user number then press [OK].
dEL ?
4) The keypad will now prompt you to conrm the
erasure by pressing [OK].
Access > PIN Codes >
ch-PiN
Change Own PIN

-

-

MENU 1-1-0
This menu lets you change your own PIN. It is
recommended that you write down your old PIN and the
new one before you begin. The new PIN must have the
same number of digits as your old PIN unless the variable
PIN length option has programmed by your installer. Once
the change is complete you should destroy the written
copy.
At factory default, each PIN is xed to 4 digits in length.
1) Enter your Installer PIN or Master PIN + [MENU]
2) Enter [1] + [1] + [0] + [OK].
The keypad will prompt you to enter a new PIN.
EntPin
3) Enter your new PIN, and then press [OK].
If an error tone sounds and the display reads “bAdPin”
you should try a dierent PIN. The keypad will now
prompt you to enter your new PIN again.
rEPEAT
4) To conrm your new PIN, enter your new PIN again.
5) Press [OK] to save and exit, or press [MENU] to exit
without saving. Your PIN has now been changed.
Access > PIN Codes >
ch-Oth
Change Other PIN

-

MENU 1-1-1
This menu allows a master user or Installer PIN to change
somebody else’s PIN. It is recommended that you write
down the old PIN and the new one before you begin.
Once the change is complete you should destroy the
written copy. The new PIN must have the same number of
digits as the old PIN.
At factory default, each PIN is xed to 4 digits in length.
The default PIN for User 1 (Master user) is 2580.

Bosch Solution 16i Specifications

General

Brand	Bosch
Model	Solution 16i
Category	Security System
Language	English