Bosch Solution 16i - Table 34: Daylight Savings Dates - Australia

11-4
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  System Programming
hh =21
6) Use the numeric keys to enter the correct hour (00
-23). The keypad will display the currently
programmed minute of the day.
mm =35
7) Use the numeric keys to enter the correct minute
(01 -59).
8) Use the [←] and [→] keys at any time to conrm
programming, then press [OK] or [MENU] to exit.
System > Clock > St-On
Summertime On

-

MENU 7-1-1
- - - - - - - - -
At 2:00am MONTH WEEK DAY
This menu allows you to program when day light savings
start during the year. This will allow the control panel to
automatically adjust it’s built in clock accordingly. See
the section on Australian daylight savings times for more
information.
To program Summertime On, you will need to set the
month of the year (Jan to Dec), the week of the month
(1 to 5) and the day of the week (Sun to Sat) that daylight
savings starts.
January = Month 1 December = Month 12
First Week = 1 Last Week = 5
Sunday = Day 1 Saturday = Day 7
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [7] + [1] + [1] + [OK].
MM =10
3) Enter the number of the month (January = 01 /
December = 12) that Summer Time starts.
WW =05
4) Enter the number of the week (First Week = 1 / Last
Week = 5) in that month that Summer Time starts.
dd =01
5) Enter the number of the day in the week (Sunday =
01 / Saturday = 07) Summer Time starts
6) Use the [←] and [→] keys at any time to conrm
programming and then press [OK] to exit.
Australian Daylight Savings Times
From 2008, the ACT, NSW, South Australia, Victoria and
Tasmania will all start daylight savings on the rst Sunday
in October and end on the rst Sunday in April. This will
result in an extra month of daylight savings for the ACT
and introduces common start and nish dates in these
states.
Daylight Saving Begins Daylight Saving Ends
Turn Clock Ahead 1 hr Turn Clock Back 1 hr
Sunday 2 October 2011 Sunday 1 April 2012
Sunday 7 October 2012 Sunday 7 April 2013
Sunday 6 October 2013 Sunday 6 April 2014
Table 34: Daylight Savings Dates - Australia
System > Clock > St-Off
Summer Time O

-

MENU 7-1-2
- - - - - - - - -
At 2:00am MONTH WEEK DAY
This menu allows you to program when day light
savings end during the year. This will allow the panel to
automatically adjust it’s built in clock accordingly.
To program Summer time O, you will need to program
the month of the year (Jan to Dec), the week of the month
(1 to 5) and the day of the week (Sun to Sat) that daylight
saving ends.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [7] + [1] + [2] + [OK].
MM =03
3) Enter the number of the month (January = 01 /
December = 12) that Summer Time ends.
WW =05