Bosch Solution 16i - Table 23: Default User Names

5-6
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Access Programming
Each user has a default name which can be changed if
desired. The default names are as follows.
DEFAULT USER NA MES
User Number Default Name
1 USEr 1 nAmE
2 USEr 2 nAmE
↓ ↓
48 USEr 48 nAmE
Table 23: Default User Names
To change a user name,
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [1] + [4] + [0] + [OK].
The keypad will display the Ur = prompt.
Ur=
3) Enter the user number who’s name you want to
change, then press [OK].
The keypad will display the current User Name.
USEr 5
The cursor position is displayed by the ashing
character in the name.
4) Use the 0 to 9, [←] and [→] keys to change the user
name text as required. At any time you can use the
[↑] and [↓] keys to scroll through the complete list of
available characters.
To clear all text from the cursor position to the right,
press the [OFF] key.
5) When the user name is complete, press [OK] to save
and exit, or press [MENU] to exit without saving.
Access > User Properties > UrArEA
Area Assignment

-

MENU 1-4-1
1 Area 1 Y
2 Area 2 N
3 Area 3 N
4 Area 4 N
This menu allows the master user or installer to program
which area(s) (1 to 4) a user operate. The master user can
only assign another user to any one or multiple areas that
the master user has been assigned to. At factory default,
each user is assigned to operate Area 1.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [1] + [4] + [1] + [OK].
The keypad will display the Ur = prompt.
Ur=
3) Enter the user number who’s area assignment you
want to change, then press [OK].
Zone numbers 1 to 4 area used to display which areas
that the user has access to.
-Bit-
1 2 4
4) Use keys [1] to [4] to toggle the area assignment on
or o.
5) Press [OK] to save and exit, or press [MENU] to exit
without saving.
Access > User > Properties L142
User Options

MENU 1-4-2
1 Has Master Code Privileges Y
2 Expire PIN Code N
3 Is Arm Only Code N
4 Can Bypass Zones Y
5 Can Auto Bypass Zones Y
6 Send Open / Close Reports Y
7 Reserved N
8 Reserved N
The above options are programmable per User.
1) Enter your Installer PIN + [MENU].
2) Enter [1] + [4] + [2] + [OK] and enter the user
number required to change, then press [OK].
3) Use keys [1] to [8] to enable or disable the options
required.