Bosch Solution 16i - Table 36: Default Holiday Names

11-13
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  System Programming
S YS TE M HO LI DAYS
The Solution 16i has provision for up to 8 individual holiday
time periods which can be used to allow or deny access
to users or to operate outputs via schedules. Holidays are
dened by setting a start and stop date so it is possible
to create 1 system holiday that spans multiple days. For
example the holiday could start on the 1st Jan and end on
the 5th Jan.
System > Holidays > hONAme
Name

-

MENU 7-6-0
H o l i d a y 1 N a m e
This menu allows the master user to program the holiday’s
name. A maximum of 16 characters can be entered in this
eld. Use the [←] and [→] keys to scroll the cursor left and
right to view the entire name.
DEFAULT HOLIDAY NAME S
Holiday Number Default Name
1 HolidAy 1 NAme
2 HolidAy 2 NAme
↓ ↓
8 HolidAy 8 NAme
Table 36: Default Holiday Names
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [7] + [6] + [0] + [OK].
The keypad will display the Ho = prompt.
Ho=
3) Enter which holiday name (1 to 8) that you want to
program, then press [OK].
The keypad will display the rst 6 characters of the
holiday name.
HolidA
4) Use the [0] to [9], [←] and [→] keys to program the
new holiday name text as required.
At any time you can use the [↑] and [↓] keys to scroll
through the complete list of available characters.
To clear all text from the cursor position to the right,
press the [OFF] key.
5) When the holiday name is complete, press [OK] to
save and exit, or press [MENU] to exit without saving.
System > Holidays > hOtime
Start / Stop Dates

-

MENU 7-6-1
START 12:00AM STOP 12:00AM
0 0 : 0 1 0 0 : 0 1
D D M M D D M M
(DAY) (MONTH) (DAY) (MONTH)
This menu allows you to program the duration of each
holiday stored in the panel. This is done by programming
the start and stop date for each holiday period. Holidays
can be as short as one day and as long as a week or more.
The following prompts will be shown when entering the
holiday parameters.
Sdd = Start Date (day of the month)
Smm = Start Month (month of the year)
Ehh = End Date (day of the month)
Emm = End Month (month of the year)
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [7] + [6] + [1] +[OK].
The keypad will display the Ho = prompt.
HO=
3) Enter the Holiday number you want to program,
then press [OK].
Sdd=01
4) Enter the day (01 - 31) of the month that the holiday
will start.
SMM=01
5) Enter the month (01 - 12) that the holiday will start.
Edd=01
6) Enter the day (01 - 31) of the month that the holiday
will end.
7)