Bosch Solution 16i - Page 127

11-3
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  System Programming
3) Press [OK] to start the default process or press
[MENU] to cancel and exit.
4) The keypad will display the following message
during the default process and will exit back to the
menu when nished.
-bUSy-
i
Note
During a factory default both the Status and Dialer
LED indicators on the panel will ash very quickly to
indicate defaulting is still in progress.
System > Commands > L705
Template Default

MENU 7-0-5
This command allows the installer to download pre-
congured templates set up by the Installer on the
MyAlarm web interface. The installer can congure up to
4 separate templates.
This feature is currently reserved.
System > Commands > L708
Service Mode

MENU 7-0-8
This command allows the installer to put the panel into
service mode before performing system maintenance or
upgrades. When in service mode, the following functions
are disabled. By default, service mode will automatically
terminate after 2 hours if not terminated sooner by the
installer.
 Zone Tamper
 Alarm Outputs
 Dialler
 Panel Tamper
1) Enter your Installer PIN + [MENU].
2) Enter [7] + [0] + [8] + [OK]. The keypad will display
the current service mode status.
is Off
3) To turn service mode on, press [ON], or press [OFF]
to turn service mode o.
4) Press [OK] or [MENU] to exit when nished.
When you exit programming mode, the keypad will
display ‘SEruic’ whilst service mode is active.
servic
i
Note
Service mode will automatically exit after 2 hours if
set to do so in MENU 7-7-4 — Installer Options.
S YS TE M CLO C K
System > Clock > cLock
Set Date & Time

-

MENU 7-1-0
This menu allows you to program or adjust the system’s
clock.
The keypad allows you to easily program the system’s
date and time seperating the day, month, year, hour and
minutes over 5 dierent screens.
At any time you can toggle between screens by pressing
the [←] and [→] keys. You should step through all 5
screens to conrm the time and date are correct before
pressing the [OK] key to exit.
See the example below. 01/01/2008 21:53
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [7] + [1] + [0] + [OK].
The keypad will display the currently programmed
day of the month.
dd =01
3) Use the numeric keys to enter the correct day (1 -
31).
The keypad will display the currently programmed
month.
mm =01
4) Use the numeric keys to enter the correct month (1
-12). The keypad will display the currently
programmed
year.
yy =08
5) Use the numeric keys to enter the last 2 digits of the
current year (01 -99).
The keypad will display the currently programmed
hour of the day in 24hr time.