Bosch Solution 16i - Page 126

11-2
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  System Programming
System > Commands > HiSLOG
History Log

-

-

MENU 7-0-2
This command allows you to review the last 256 history
events in chronological order. Each log entry provides a
wealth of information about the event including log even
number, time and date stamp, user and zone names and
the report route used.
When you enter the history log the most recent event will
always be shown rst. Once the log memory is full it will
wrap and begin overwriting the oldest event in memory.
Each event will show up to 7 dierent screens, each
screen displaying a dierent part of the history event.
By combining all the dierent screens together, you can
determine the actual event:
Screen 1 Displays: The History Event Number.
Screen 2 Displays: The Trouble Description #1.
Screen 3 Displays: The Trouble Description #2.
Screen 4 Displays: The Device Number.
Screen 5 Displays: The Date The Event Occurred.
Screen 6 Displays: The Time The Event Occurred.
Screen 7 Displays: The Reporting Information.
Destination 1 and /or 2 report status (S= Sent, P =
Pending, F = Fail, A = Abort and L = Log Only).
1) Enter your PIN + [MENU].
2) Enter [7] + [0] + [2] + [OK]. The keypad will display
the most recent event from the history log.
E123
bAttry
trbl
P001
03 jAn
21-15
S1-L2
3) Use the up and down arrows keys to scroll between
history events .
4) When nished press [OK] or [MENU] to exit.
System > Commands > L703
Domestic Default

MENU 7-0-3
This command will congure the control panel for
Domestic format reporting (eg. mobile telephones
etc). All alarm restore reports and open/close reporting
options will be automatically disabled. Therefore, only
emergency, burglary and re reports will be sent.
1) Enter your PIN + [MENU].
2) Enter [7] + [0] + [3] + [OK]. The keypad will display:
ddEF?
3) Press [OK] to start the default process or press
[MENU] to cancel and exit.
4) The keypad will display the following message
during the default process and will exit back to the
menu when nished.
-bUSy-
System > Commands > L704
Factory Default

MENU 7-0-4
This command will erase ALL programmable data and
return the control panel to factory default settings.
Defaulting the panel will NOT erase any history events
that are currently stored in the panel.
1) Enter your Installer PIN + [MENU].
2) Enter [7] + [0] + [4] + [OK]. The keypad will display:
FdEF?