Bosch Solution 16i - Page 88

8-10
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Output Programming
Display Missing Output Device
This option allows the panel to display a trouble
condition when it detects that the output device is
missing. The trouble condition will clear when the
output device has been restored.
Report Missing Output Device
This option causes the panel to send an Output Trouble
report when it detects that the output device is missing.
A restore report will be sent when the when the output
device is reconnected.
Alarm When Missing Output Device
This option causes the panel to sound an alarm when the
output device becomes missing.
Block If Armed All On
This option prevents the output from turning on when
the corresponding area is turned All On. When the area
is o, Part On or Part 2 On, the output can again operate
when the output event occurs.
Display Output Status On Keypad
This option allows the keypad to display the output that
is currently active on the keypad.
Outputs > Properties > L416
Macro Group

MENU 4-1-6
Reserved
O UT PU T T ES TIN G
Outputs > Testing > L490
External Siren Test

-

MENU 4-9-0
This menu allows you to test the external sirens
which have been connected to the system.
The test will last for 5 seconds.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [4] + [9] + [0] + [OK].
If your system has been congured to have more than
one area, the keypad will display the A = prompt.
A=
3) Enter the Area number in which to test the external
sirens in and then press [OK].
Siren

ALARM
The keypad will display ‘Siren’ and the alarm icon
during the audible 3 second siren test.
Outputs > Testing > L491
Internal Bell Test

-

MENU 4-9-1
This menu allows you to test any internal sirens which
have been connected to the system. The test will last for
3 seconds.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [4] + [9] + [1] + [OK].
If your system has been congured to have more than
one area, the keypad will display the A = prompt.
A=
3) Enter the Area number in which to test the internal
sirens in and then press [OK].
BELL

ALARM
The keypad will display ‘Bell’ and the alarm icon during
the audible 3 second internal siren test.
Outputs > Testing > L492
Strobe Siren Test

-

MENU 4-9-2
This menu allows you to test the external strobe lights
tted to the system. The test will last for 1 minute.
1) Enter your Installer PIN or Master PIN + [MENU]
2) Enter [4] + [9] + [2] + [OK].
If your system has been congured to have more than
one area, the keypad will display the A = prompt.
A=
3) Enter the area number in which to test the strobe
lights in and then press [OK].
StrObe

ALARM
During the 60 second strobe test, the keyapd will
display both the word ‘Strobe’ and also the alarm icon.