Boumatic TouchPoint - Page 19

SmartControl™ Meter & TouchPoint™ 19 9E-926
Operation Instructions
5. Select the appropriate Function Key to determine what ac-
tion is to be done:
-Press [Chg Cow] (F1) to change the cow number at
this stall only.
-Press [Ins Cow] (F2) to insert the new cow number
and move the rest of the cows towards the entrance.
-Press [Del Cow] (F3) to remove the cow number and
move the rest of the cows from here to enter over
one stall.
9. Screen 7: Cow Change Action l926_9
Cow Number
Cow 147
Milk Weight (lb) .00
Lot Number 18
Chg Ins Del
Cow Cow Cow
Procedure when the milking unit is attached:
1. Enter the desired cow number.
2. Correct cow number and enter number:
-Press [Back] (F1) to cancel the cow number change
and return to the original cow number.
-Press [Clear] (F2) to clear the cow number to zero (0).
-Press [Bksp] (F3) to erase the last digit.
-Press [Enter] (F4) to enter the cow number shown
(see Figure 7).
3. Conrm [Are You Sure?] (F2) or cancel entry of the cow
number shown:
-Press [No] (F1) to cancel the cow number change.
-Press [Yes] (F4) to conrm the entry of the cow
number shown (see Figure 8).
4. Select the appropriate Function Key to determine what ac-
tion is to be done:
-Press [Chg Cow] (F1) to change the cow number at
this stall only.
-Press [Ins Cow] (F2) to insert the new cow number
and move the rest of the cows toward the entrance.
-Press [Del Cow] (F3) to remove the cow number and
move the rest of the cows from the entrance over
one stall (see Figure 9).