9E-926 32 SmartControl™ Meter & TouchPoint™
Operation Instructions
2.1.10.3 Treat Cow
If a cow number has been assigned it is possible to assign a
treatment to the cow in the SmartDairy Controller.
Parameters:
1. SmartDairy Controller required
2. Used on all parlor types
Procedure:
1. Using the [ ] (F4) key scroll through the available Function
Keys until [Treat Cow] (F3) is available.
24. Screen 22: Treat Cow l926_24
3.5 23.5
Time Milk
Cow 7705
Milk Weight (lb) 23.47
Expected Milk 47.80
MS/cm 5.3( 7.6)
ID End Treat
Chek Milk Cow
2. A screen will appear with several (up to ve) treatment
choices. Press the numeric key that matches the treatment
you wish to assign to this cow. If the treatment you want to
assign is not displayed, press the [Prev Page] (F2) or [Next
Page] (F3) keys to see the previous or next set of choices.
The entire list will be displayed regardless of which (previ-
ous or next) you press. There are a maximum of ten treat-
ments possible. When you press a digit key a message will
be sent to the SmartDairy Controller to assign the treat-
ment to that cow. If you do not want to assign a treatment
press the [ ] key (F4) to cancel this function.
25. Screen 23: Treatment Codes l926_25
7705
Cow Number
0:No Treatment
1:Dry this cow off
2:Mastitis rear
3:Mastitis front
4:BGH
Prev Next
Pate Page
— NOTICE ———————
The data to be displayed will be de-
termined by the SmartDairy Control-
ler.
To Next Page
Loading...