9E-926 20 SmartControl™ Meter & TouchPoint™
Operation Instructions
2.1.8.5 Manual Activation of Cylinder
2.1.8.5.1 Cylinder Up
The detach cylinder can be manually controlled without open-
ing the shutoff. Pressing the Function key will only activate the
cylinder on the stall where the TouchPoint is located.
Parameters:
1. SmartDairy™ Controller not required
2. Used on all parlor types
Procedure:
1. Enter “9173” to unlock the keypad if not Attached.
2. Using the [ ] (F4) key, scroll through the available Function
Keys until [Cyl Up] (F1) is available.
3. Press the appropriate Function Key (F1).
10. Screen 8: Manual Activation of Cylinders l926_10
Cow Number
Cow -----
Milk Weight (lb) .00
Cyl Cyl Zone
Up Down Down
To Next Page
Loading...