9E-926 50 SmartControl™ Meter & TouchPoint™
Operation Instructions
4.2 Understanding the Automatic/
Manual Modes
The user may operate controls in either the Automatic (auto-
matic takeoff) mode or the Manual (takeoff) mode by pressing
the corresponding control key.
When using the control in Automatic mode, set it to activate an
Automatic takeoff delay. This delay responds to low milk ow
rate (calculated by the control electronics) to determine end-
of-milk conditions and the eventual automatic Detach of the
milking unit.
Operating the control in Manual mode overrides milk ow mon-
itoring causing the control to ignore the takeoff delay and re-
main attached indenitely or until the maximum milking time
has been reached. As a result, the milking unit must be de-
tached manually by pressing the corresponding control key.
To Next Page
Loading...