Boumatic TouchPoint - Cylinder down; Zone down

SmartControl™ Meter & TouchPoint™ 21 9E-926
Operation Instructions
2.1.8.5.2 Cylinder Down
The detach cylinder can be manually controlled without open-
ing the shutoff. Pressing the Function key will only activate the
cylinder on the stall where the TouchPoint is located.
Parameters:
1. SmartDairy™ Controller not required
2. Used on all parlor types
Procedure:
1. Enter “9173” to unlock the keypad if not Attached.
2. Using the [ ] (F4) key, scroll through the available Func-
tion Keys until [Cyl Down] (F2) is available.
3. Press the appropriate Function Key (F2) (see Figure 10).
2.1.8.5.3 Zone Down
The detach cylinder can be manually controlled without open-
ing the shutoff. Pressing the Function key will activate all cyl-
inders in that zone.
Parameters:
1. SmartDairy™ Controller not required
2. Used on all parlor types
Procedure:
1. Enter “9173” to unlock the keypad if not Attached.
2. Using the [ ] (F4) key, scroll through the available Func-
tion Keys until [Zone Down] is available.
3. Press the appropriate Function Key (F3) (see Figure 10).