Boumatic TouchPoint - Page 2

Instructional Content and Purpose
These instructions aim to aid those responsible (outlined under
“Responsibilities”) for installing, operating, maintaining, troubleshooting,
and servicing this product.
Responsibilities
Procedures in these instructions are to be performed according to
applicable codes (state, local, and other) by the person(s) qualied
(licensed, if applicable) to do so —that is:
• Welding must be done by a qualied welder;
• AC power wiring for voltages over 40V (50V in Europe) must be done
by a qualied (licensed) electrician in compliance with the latest edition
of the ANSI/NFPA Standard 70, National Electrical Code, (USA) or either
LVD 73/23/EEC or EMC 89/336/EEC (Europe) and in compliance with
the local wiring codes as applicable;
• Other installation, major maintenance, and service work must be
done by an authorized BouMatic
®
dealer;
• Product/system checkout and troubleshooting steps are to be
performed by an authorized BouMatic
®
dealer;
• Deviation from these instructions could affect product performance or
create a hazardous situation. Under no circumstances will BouMatic
®
be responsible for any problems caused in whole or in part by any
deviation from the procedures specied in these instructions without
prior written approval from BouMatic
®
;
• Operation steps may be performed by the owner/operator once the
dealer or technician has successfully nished the product/system
checkout. The owner/operator is responsible for properly operating,
maintaining, and monitoring the product/system to ensure that it
works properly.
Close compliance with the procedures herein is essential for the owner
to get maximum benet from the product/system.
Disclaimers
No warranties are contained in these instructions. The division of
responsibilities, stated above, is a general reminder of those provisions
in the applicable dealer contract and does not change any agreement
between BouMatic
®
and the dealer. Information in these instructions is
not all-inclusive and cannot cover all unique situations.
9E-926-0911 TouchPoint™ and SmartControl™ Meter Operation Instructions
Instructional Content and Purpose
These instructions aim to aid those responsible (outlined under
“Responsibilities”) for installing, operating, maintaining, troubleshooting,
and servicing this product.
Responsibilities
Procedures in these instructions are to be performed according to
applicable codes (state, local, and other) by the person(s) qualied
(licensed, if applicable) to do so —that is:
• Welding must be done by a qualied welder;
• AC power wiring for voltages over 40V (50V in Europe) must be done
by a qualied (licensed) electrician in compliance with the latest edition
of the ANSI/NFPA Standard 70, National Electrical Code, (USA) or either
LVD 73/23/EEC or EMC 89/336/EEC (Europe) and in compliance with
the local wiring codes as applicable;
• Other installation, major maintenance, and service work must be
done by an authorized BouMatic
®
dealer;
• Product/system checkout and troubleshooting steps are to be
performed by an authorized BouMatic
®
dealer;
• Deviation from these instructions could affect product performance or
create a hazardous situation. Under no circumstances will BouMatic
®
be responsible for any problems caused in whole or in part by any
deviation from the procedures specied in these instructions without
prior written approval from BouMatic
®
;
• Operation steps may be performed by the owner/operator once the
dealer or technician has successfully nished the product/system
checkout. The owner/operator is responsible for properly operating,
maintaining, and monitoring the product/system to ensure that it
works properly.
Close compliance with the procedures herein is essential for the owner
to get maximum benet from the product/system.
Disclaimers
No warranties are contained in these instructions. The division of
responsibilities, stated above, is a general reminder of those provisions
in the applicable dealer contract and does not change any agreement
between BouMatic
®
and the dealer. Information in these instructions is
not all-inclusive and cannot cover all unique situations.