SmartControl™ Meter & TouchPoint™ 4 9E-926
Operation Instructions
Table of Contents
4.1.2 Principle of Operation................................................................... 47
4.1.3 Electronic Control......................................................................... 48
4.2 Understanding the Automatic/Manual Modes................................................. 50
4.2.1 Automatic Mode—Let-Down Delay................................................... 51
4.2.2 Automatic Mode—Early Detach, at end of Let-Down Delay.................. 51
4.2.3 Automatic Mode—Normal Detach.................................................... 51
4.2.4 Manual Mode................................................................................ 52
4.3 Using the Milking System........................................................................... 53
4.3.1 Milking........................................................................................ 53
4.3.2 Wash.......................................................................................... 54
4.4 Using the Milk Sampler............................................................................... 55
5. Troubleshooting.................................................................................................... 56
6. Maintenance......................................................................................................... 59
6.1 Meter Accuracy Test Procedure.................................................................... 59
6.1.1 Instructions for SmartControl Milk Meters......................................... 59
6.1.2 Flask Calibration for Non BouMatic Flask.......................................... 59
6.1.3 Test Procedure............................................................................. 59
6.1.4 After Every Milking........................................................................ 62
6.2 As Needed................................................................................................ 63
6.3 Avoid Exposure of Plastic Parts.................................................................... 63
6.4 Yearly Maintenance.................................................................................... 63
6.5 As Necessary Maintenance.......................................................................... 63
7. Service................................................................................................................ 64
7.1 Replacing the Controls............................................................................... 64
7.1.1 To Change Parameters or Upgrade the Software for a control to
be used for replacement...................................................................... 64
7.2 Replace the TouchPoint............................................................................... 65
7.3 Replace the Control Circuit Board in the SmartControl.................................... 66
7.4 Meter Maintenance.................................................................................... 67
7.4.1 Replace the Diaphragm Assembly.................................................... 67
7.4.2 To replace the O-ring Seal.............................................................. 68
7.4.3 Replace Upper Gasket................................................................... 68
7.4.4 Replace Lower Gasket................................................................... 68
7.5 Upgrade Software on all Controls in Parlor..................................................... 69
7.6 Replacing the Meter Outlet.......................................................................... 70
7.6.1 Meter Outlet, One Sensor............................................................... 71
7.6.2 Meter Outlet, Two Sensors............................................................. 72
To Next Page
Loading...