4-8 BBP
®
33 Sign & Label Printer
User’s Manual
Printer Maintenance
Cleaning the Printer
4. Clean metal cutting blade [4]:
a. If the cutting blade shows significant residue, use the adhesive scraping
tool from the cleaning kit, or other flat-edged tool, to gently scrape the
reside off the cutting blade.
b. Moisten one of the foam swabs from the cleaning kit with the alcohol. Do
not allow the alcohol to drip from the swab.
c. Clean cutting blade with moistened swab until all residue is removed.
5. Close the cutting blade by pushing up on the exit chute until the cutter tabs
snap into place.
Note: You may need to hold ribbon cover up slightly to access the exit chute.
6. Replace the ribbon and tape.
7. Close all covers and plug in the power cord.
To Next Page
Loading...
