brielmaier S250 - Page 48

4 | Start-up Brielmaier Motormäher GmbH
48 BA Motor mower S250 (Version 2021/09)
Disconnecting the
attachment
The attachment is disconnected as follows:
a) Place the steering bar in the rear driving position and secure it in place.
1
2
b) Loosen the locking screw (1) on the support foot of the attachment (2)
(if present).
c) Push the support foot down.
d) Fix and tighten the locking screw in the upper hole.
e) If there is no parking support on the attachment, use suitable tools
(jack, wooden block).
3
4
f) Make sure that the machine is switched off.
g) Pull off the supply line (3) (thin hose).
h) Pull off the return line (4) (thick hose).
i) Fold hoses forward (so that they are out of the working zone and
protected from being run over, etc.)
5
j) Remove the safety cotter pin (5).
5
6
k) Open the quick-release lever (6) on the machine.
5
l) Start the machine.
5
8
7
m)Tilt the machine slightly forward until the upper lug of the quick-
release fastener (7) is unhooked from the quick-release coupling (8), the
parking support is on the ground or the attachment is resting on the
tool.
n) Move the machine backwards until it can be straightened up again.
o) Park the machine securely and stable on flat terrain (see chapter
Parking the machine safely without attachments [}55]).
p) Switch off the engine.
q) Move the steering bar back into the working position.