brielmaier S250 - Page 91

Brielmaier Motormäher GmbH Maintenance | 7
BA Motor mower S250 (Version 2021/09) 91
Setting the steering
parameters
To set the steering parameters:
1
2
a) Press and hold the "Attachment drive ON/OFF" button (1).
ð The "hydraulic oil temperature" display (2) flashes.
3
b) Turn the steering twist handle (3) in both directions.
ð The values shown on the display should be in the range between 50 and
950.
4
ð The "hydraulic oil temperature" display (4) lights up continuously.
c) Release the "Attachment drive ON/OFF" button.
5
d) Press and hold the "+" (5) button on the right grip.
6
ð The "fault" display (6) flashes.
7
e) Move the steering twist handle (7) slightly to the right and left. Only
move within the play. (Dead gear in neutral position.)
ð The values shown on the display should be in the range between 50 and
950.
8
ð The "fault" display (8) lights up continuously.
f) Release the "+" button.
g) Switch off the machine.