Brother MFC-9560CDW - Page 106

2-67
Confidential
■ Error code 85
The paper tray 1 is not installed.
<User Check>
- Check if the paper tray 1 is installed into the machine.
- Check if the paper is jammed in the paper tray 1. If jammed, remove it.
■ Error code 86
The paper tray 2 is not installed.
<User Check>
- Check if the paper tray 2 is installed into the machine.
- Check if the paper is jammed in the paper tray 2. If jammed, remove it.
(Non Touch panel model)
No Tray
A Tray is not detected, install #1.
(Touch panel model)
No Tray
The paper tray cannot be detected, re-install Tray#1.
Step Cause Remedy
1 Harness connection failure of
T1 paper edge sensor PCB
ASSY
Check the harness connection of the
T1 paper edge sensor PCB ASSY and
reconnect it.
2 T1 paper edge sensor PCB
failure
Check the sensor performance following
the procedure described in “Function code
32”. If any problem occurs, replace the
T1 paper edge sensor PCB ASSY.
3 Engine PCB failure Replace the engine PCB ASSY.
4 Main PCB failure Replace the main PCB ASSY.
(Non Touch panel model)
No Tray
A Tray is not detected, install #2.
(Touch panel model)
No Tray
The paper tray cannot be detected, re-install Tray#2.
Step Cause Remedy
1 Harness connection failure of
T2 sensor PCB ASSY
Check the harness connection of the
T2 sensor PCB ASSY and reconnect it.
2 Harness connection failure of
T2 Relay PCB ASSY
Check the harness connection of the
T2 Relay PCB ASSY and reconnect it.
3 T2 paper edge sensor PCB
failure
Check the sensor performance following
the procedure described in “Function code
32”. If any problem occurs, replace the
T2 paper feed frame unit.
4 T2 Relay PCB failure Replace the T2 Relay PCB ASSY.
5 Engine PCB failure Replace the engine PCB ASSY.
6 Main PCB failure Replace the main PCB ASSY.