Troubleshooting and routine maintenance
141
C
Setting Dial Tone detection C
When you send a fax automatically, by
default your machine will wait for a fixed
amount of time before it starts to dial the
number. By changing the Dial Tone setting to
Detection you can make your machine dial
as soon as it detects a dial tone. This setting
can save a small amount of time when
sending a fax to many different numbers. If
you change the setting and start having
problems with dialling you should change
back to the default No Detection setting.
a (for New Zealand) Press Menu, 0, 4.
Press Menu, 0, 5
b Press a or b to choose Detection or
No Detection.
Press OK.
c Press Stop/Exit.
Telephone line interference C
If you are having difficulty sending or
receiving a fax due to possible interference
on the telephone line, we recommend that
you adjust the Equalization for compatibility
to reduce the modem speed for fax
operations.
a Press Menu, 2, 0, 1.
b Press a or b to choose
Basic(for VoIP), Normal or High.
Basic(for VoIP) cuts the
modem speed to 9600 bps and turns
the error correction mode (ECM) off.
For a standard telephone line: If you
regularly experience interference on
your standard telephone line try this
setting.
If you are using VoIP: VoIP service
providers offer fax support using
various standards. If you regularly
experience fax transmission errors
try this setting.
Normal sets the modem speed at
14400 bps.
High sets the modem speed at
33600 bps.
Press OK.
c Press Stop/Exit.
Note
When you change the Compatibility to
Basic(for VoIP), the ECM feature is
only available for colour fax sending.
To Next Page
Loading...
Need help?
General
