Chapter 4
34
Setting Lock 4
Setting Lock lets you set a password to stop
other people from accidentally changing your
machine settings.
Make a careful note of your password. If you
forget it, you will have to reset the passwords
stored in the machine. Please call your
administrator or your Brother dealer.
While Setting Lock is On, you cannot change
the following settings without a password:
Date/Time
Station ID
Quick Dial settings
Mode Timer
Paper Type
Paper Size
Volume
Daylight Save
Ecology
LCD Contrast
Setting Lock
Secure Function Lock (MFC-9320CW)
Memory Security (MFC-9120CN)
Dial Restriction
Setting up the password 4
a Press Menu, 1, 7, 2.
b Enter a four-digit number for the
password using numbers 0–9.
Press OK.
c Re-enter your password when the LCD
shows Verify:.
Press OK.
d Press Stop/Exit.
Changing your Setting Lock
password 4
a Press Menu, 1, 7, 2.
b Press a or b to choose Set Password.
Press OK.
c Enter your four-digit password.
Press OK.
d Enter a four-digit number for the new
password.
Press OK.
e Re-enter your new password when the
LCD shows Verify:.
Press OK.
f Press Stop/Exit.
Turning Setting Lock on/off 4
If you enter the wrong password when
following the instructions below, the LCD will
show Wrong Password. Re-enter the
correct password.
Turning Setting Lock on
a Press Menu, 1, 7, 2.
b Press a or b to choose On.
Press OK.
c Enter your four-digit password.
Press OK.
d Press Stop/Exit.
Turning Setting Lock off
a Press Menu, 1, 7, 2.
b Enter your four-digit password.
Press OK twice.
c Press Stop/Exit.
To Next Page
Loading...
Need help?
General
