Troubleshooting and routine maintenance
165
C
e Press Stop/Exit.
Note
• If an error message is displayed, press
Stop/Exit and try again. For more
information, see Error and maintenance
messages on page 142.
• If you print using Windows
®
printer driver,
you need to perform the calibration from
the Windows
®
printer driver. See
Advanced tab in the Software User's
Guide on the CD-ROM.
• If you print using the Macintosh printer
driver, you need to perform the calibration
using the status monitor. See Status
Monitor in the Software User's Guide on
the CD-ROM. When the Status Monitor
is open, choose Control / Color
Calibration from the menu bar.
Auto Registration C
Registration C
If solid areas of colour or images have cyan,
magenta or yellow fringes, you can use the
auto-registration feature to correct the
problem.
a Press Menu, 4, 6, 1.
b To start, press 1.
To exit, press 2.
c Press Stop/Exit.
Frequency C
You can set the machine to carry out auto
registration regularly, and also how often it
occurs.
a Press Menu, 4, 6, 2.
b Press a or b to choose Low, Medium,
High or Off.
Press OK.
c Press Stop/Exit.
Manual Registration C
If colour still appears incorrectly after auto-
registration, you will need to perform manual
registration.
a Press Menu, 4, 7, 1.
b Press Mono Start or Colour Start to
start printing the colour registration
chart.
c When the machine has finished printing
the registration sheet,
press 2 (Set Regist.) to correct the
colour manually.
d Starting at 1 (Magenta) on the chart,
check which coloured bar has the most
uniform print density and enter its
number into the machine using the
a and b keys.
Press OK.
Repeat for 2 (Cyan), 3 (Yellow), 4, 5, 6
to 9.
e Press Stop/Exit.
To Next Page
Loading...
Need help?
General
