Security features
33
4
Setting up the password 4
Note
• If you have already set the password, you
will not need to set it, again.
• If you forget the Memory Security
password, please call your Brother dealer.
a Press Menu, 1, 7, 1.
Security
1.Mem Security
b Enter a four-digit number for the
password using numbers 0–9.
Press OK.
c Re-enter the password when the LCD
shows Verify:.
Press OK.
d Press Stop/Exit.
Changing your memory
security password 4
a Press Menu, 1, 7, 1.
Security
1.Mem Security
b Press a or b to choose Set Password.
Press OK.
c Enter your four-digit password.
Press OK.
d Enter a four-digit number for the new
password.
Press OK.
e Re-enter the password when the LCD
shows Verify:.
Press OK.
f Press Stop/Exit.
Turning memory security
on/off 4
If you enter the wrong password when
following the instructions below, the LCD will
show Wrong Password. Re-enter the
correct password.
Turning memory security on
a Press Menu, 1, 7, 1.
Security
1.Mem Security
b Press a or b to choose Set Security.
Press OK.
c Enter your registered four-digit
password.
Press OK.
The machine goes offline and the LCD
shows Secure Mode.
Note
If there is a power failure faxes will remain
in memory for up to 60 hours.
Turning memory security off
a Press Menu.
Enter the registered four-digit password.
Press OK.
b Memory Security is automatically turned
off and the LCD shows the date and
time.
Note
If you enter the wrong password, the LCD
shows Wrong Password and stays
offline. The machine will stay in Secure
Mode until the registered password is
entered.
To Next Page
Loading...
Need help?
General
