Brother MFC MFC-9120CN - LCD Contrast; Dial Prefix

General Setup
27
3
LCD Contrast 3
You can change the contrast to make the
LCD look lighter or darker.
a Press Menu, 1, 6.
b Press a to make the LCD darker. Or,
press b to make the LCD lighter.
Press OK.
c Press Stop/Exit.
Dial Prefix 3
The Dial Prefix setting will automatically dial a
predefined number before every fax number
you dial. For example: If your telephone
system requires a 9 to dial an outside number
use this setting to automatically dial 9 for
every fax you send.
Setting up the prefix number 3
a (for New Zealand) Press Menu, 0, 5.
Press Menu, 0, 6.
b Enter the prefix number (up to 5 digits)
on the dial pad.
Press OK.
Note
• You can use the numbers 0 to 9, #, l
and !. (Press Hook to display “!”.)
You cannot use ! with any other numbers
or characters.
If your telephone system requires a timed
break recall (hookflash), press Hook to
enter the break.
• (Not available in New Zealand) If the pulse
dialing mode is on, # and l are not
available to use.
c Press Stop/Exit.