Loading paper and documents
17
2
Acceptable paper and
other print media
2
Print quality may vary according to the type of
paper you are using.
You can use the following types of print
media: thin paper, plain paper, thick paper,
bond paper, recycled paper, labels or
envelopes.
For best results, follow the instructions below:
Use paper made for plain paper copying.
Use paper that is 75 to 90 gsm.
DO NOT put different types of paper in the
paper tray at the same time because it
may cause paper jams or misfeeds.
For correct printing, you must choose the
same paper size from your software
application as the paper in the tray.
Avoid touching the printed surface of the
paper immediately after printing.
Use long grain paper with a neutral Ph
value, and a moisture content of
approx. 5%.
Type and size of paper 2
The machine loads paper from the installed
standard paper tray or manual feed slot.
Standard paper tray 2
Since the standard paper tray is a universal
type, you can use any of the paper sizes (one
paper type and size at a time) listed in the
table in Paper capacity of the paper trays
on page 18. The standard paper tray can
hold up to 250 sheets of Letter/A4, Legal or
Folio size paper (80 gsm). Paper can be
loaded up to the maximum paper mark on the
sliding paper width guide.
Manual feed slot 2
The manual feed slot can hold a sheet with a
size of 76.2 to 220 mm wide and
116 to 406.4 mm long. You can use the
manual feed slot if you are using special
paper, envelopes or labels.
The name for the paper trays in the
printer driver in this Guide are as
follows:
2
Tray and slot Name
Standard paper tray Tray
Manual feed slot Manual Feed
To Next Page
Loading...
Need help?
General
