19
ROUTINE SERVICE
OUTBOARD RIGGING CONNECTIONS
2
Install trunnion cover and screw. Tighten screw to
a torque of 60 to 80 in. lbs. (7 to 9 N·m).
Battery Cable Connections
Install battery cables on starter solenoid and main
ground stud.
SystemCheck Harness
Connections
Remove flywheel/harness connector cover.
Before installing electrical connectors, check that
the seal is in place. Clean off any dirt from con-
nectors. Apply a light coat of Electrical Grease to
the seal only. DO NOT fill connectors with Electri-
cal Grease.
Connect outboard main wire harness to boat wire
harness. Secure connectors in brackets.
1. Trunnion cover and screw, throttle cable 004958
1. Positive (+) battery connection
2. Ground (–) connection
004953
004954
1. Seal 42079A
1. Harness connections 004951
To Next Page
Loading...
