39
ROUTINE SERVICE
FUEL AND OIL SYSTEMS
2
Apply Triple-Guard grease to the gasket surface
of the spark plug. Install spark plug and tighten to
a torque of 15 ft. lbs. (20 N·m).
If the mark is in unshaded area do not tighten any-
more.
If the mark is in the shaded area, reset torque
wrench to 30 ft. lbs. (41 N·m) and continue to turn
until the mark is in the unshaded area.
If the mark does not reach the unshaded area
before the torque of 30 ft. lbs. (41 N·m) is reached,
the spark plug cannot be indexed for that cylinder.
Try another spark plug and repeat the steps
above.
FUEL AND OIL SYSTEMS
Routine replacement of filters reduces the possi-
bility of foreign material restricting the incoming
fuel or oil supplies.
Replacement filter elements are available through
Evinrude/Johnson Genuine Parts.
Fuel Filter
Evinrude E-TEC V-model outboards are equipped
with a water-sensing, water-separating fuel filter.
Refer to FUEL COMPONENT SERVICING on
p. 146.
Spark Plug Indexing Diagram
1. Unshaded area
2. Shaded area
004294
1. Water-separating fuel filter 005237
To Next Page
Loading...
