EasyManua.ls Logo

BRP EVINRUDE E-TEC 150 HP 2011 - Pre-Season Service

BRP EVINRUDE E-TEC 150 HP 2011
416 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
45
ROUTINE SERVICE
PRE-SEASON SERVICE
2
PRE-SEASON SERVICE
If the outboard was removed from the boat for
storage, make sure it is reinstalled with factory
specified hardware. Refer to the Predelivery and
Installation Guide.
Outboard Mounting Bolts
Check and re-tighten outboard mounting bolts
to a torque of 40 ft. lbs. (54 N·m).
Gearcase Lubricant
Check the lubricant level.
Inspect gearcase for leaks. If leak is apparent,
pressure and vacuum test gearcase.
Repair gearcase as needed.
Battery(s)
Replace batteries that cannot be charged.
Power Trim and Tilt
Remove filler cap and check fluid level.
Inspect the power trim and tilt unit for leaks.
Repair as needed.
Operational Checks
Refer to OPERATIONAL CHECKS on p. 31
Steering system
Remote controls
All other accessories and instrumentation
Check Oil Injection Tank
Inspect the oil tank for leaks.
Check Fuel System
Inspect entire fuel system for leaks before start-
ing outboard.
Repair all leaks.
Water Pump
Make sure a steady stream of water flows from
overboard indicator.
WARNING
Failure to check for fuel leakage could
allow a leak to go undetected, resulting in
fire or explosion.

Table of Contents

Related product manuals