243
MIDSECTION
EXHAUST HOUSING SERVICE
11
If removed, coat the lower mounts with soapy
water and press into the exhaust housing with the
“OUTSIDE” mark facing outward.
Install the mount covers. Apply Nut Lock to
screws, install washers and screws, and tighten to
a torque of 150 to 180 in. lbs. (17 to 20 N·m).
Exhaust Housing Installation
Bring the exhaust housing into position with the
stern bracket.
Install four new lower mount screws with lock-
patch. Tighten screws to a torque of 38 to 45 ft.
lbs. (51 to 61 N·m).
Install powerhead. Refer to POWERHEAD
INSTALLATION on p. 219.
Install gearcase. Refer to Gearcase GEARCASE
REMOVAL AND INSTALLATION on p. 268.
23033
32579
23036
To Next Page
Loading...
