37
ROUTINE SERVICE
LUBRICATION
2
Remove the lubricant level plug and the lubricant
drain/fill plug.
Use Gearcase Filler, P/N 501882, to slowly fill the
gearcase with HPF PRO lubricant through the
drain/fill hole until it appears at the oil level hole.
IMPORTANT: Filling the gearcase too quickly
can cause air pockets and the gearcase may not
fill completely.
Clean plug seal area and install the lubricant level
plug and new seal, then the lubricant drain/fill plug
and new seal. Tighten plugs to a torque of 60 to
84 in. lbs. (7 to 9.5 N·m).
IMPORTANT: The recommended gear lubri-
cants are formulated for marine applications. Do
not use automotive gear lubricants, engine oils, or
any other oil or grease.
Trim and Tilt
Check reservoir fluid level every three years or
every 300 operating hours.
• System capacity is approximately 21 fl. oz. (620
ml).
• Tilt the outboard and engage the tilt support.
• Remove filler cap and check fluid level.
• Three Ram System–Add Power Trim/Tilt Fluid
or GM Dexron II, as needed, to bring level to the
bottom of the fill plug threads.
1. Lubricant level plug
2. Lubricant drain/fill plug
002386
CAUTION
Correct fluid level must be maintained to
ensure operation of the impact protection
built into the unit.
1. Tilt support bracket 002279
Three Ram System, 115 - 200 HP
1. Fill cap
004277
To Next Page
Loading...
