Figures
CryoProbe Installation BRUKER 89 (93)
Figures
1Safety 7
2 Introduction 13
Figure 2.1. The CryoProbe™ System ................................................... 14
3 Initial setup 17
Figure 3.1. CryoProbe handling ............................................................ 20
Figure 3.4. Preparing the Mounting Hardware ...................................... 29
Figure 3.5. Sliding the CryoProbe into the magnet ................................ 31
Figure 3.6. CryoProbe and optional cranked pillar braces ..................... 32
Figure 3.7. Final positioning of the CryoProbe ...................................... 33
Figure 3.8. Unlock the vaccum flange screws ....................................... 35
Figure 3.9. O-rings on the CryoCoupler ................................................ 35
Figure 3.10. Turn the CryoCoupler ......................................................... 36
Figure 3.11. Inserting the CryoCoupler ................................................... 37
Figure 3.12. Attaching the He Hose ........................................................ 42
Figure 3.14. Connecting VT sensor cable and VT hose (bottom view) ..... 47
Figure 3.15. Open the CryoProbe vacuum plug ...................................... 48
Figure 3.16. Switching on the He Compressor ........................................ 50
4 Customizing the CryoProbe System 57
5 Troubleshooting 59
6 Relocation of a CryoPlatform 69
Figure 6.1. Releasing the gas from the CryoCooling Unit ...................... 70
7 Bruker contact 73
A Check lists .......................................................... 75
A Related documents ............................................. 79
Figure A.1. When to use which CryoProbe document ........................... 80
B Conversion of metric units ................................. 81
C Glossary .............................................................. 83
To Next Page
Loading...
Need help?
General
