Bruker CryoProbe System - Tables

Tables
CryoProbe Installation BRUKER 91 (93)
Tables
1 Safety 7
2 Introduction 13
3 Initial setup 17
Table 3.1. Position the units ........................................................... 21
Table 3.2. Adjust the BCU05 outlet temperature ............................. 22
Table 3.3. Mount the cranked magnet pillar braces (optional) ......... 23
Table 3.4. Replace the shim system (optional) ................................ 24
Table 3.5. Attach the Mounting Hardware ....................................... 25
Table 3.6. Mount the CryoProbe ..................................................... 28
Table 3.7. Join the CryoCoupler ..................................................... 34
Table 3.8. Booting the CryoController ............................................. 40
Table 3.9. Mount the He steel-cylinder ........................................... 41
Table 3.10. Interconnect the He Compressor .................................... 44
Table 3.11. Connect the CryoProbe .................................................. 46
Table 3.12. Power-on ....................................................................... 49
Table 3.13. VT setup ........................................................................ 51
Table 3.14. Cool-down ..................................................................... 52
Table 3.15. Installing the HPPR CRP ............................................... 54
4 Customizing the CryoProbe System 57
5 Troubleshooting 59
Table 5.1. Troubleshooting the He Compressor .............................. 63
Table 5.2. Refill He ........................................................................ 68
6 Relocation of a CryoPlatform 69
7 Bruker contact 73
A Check lists 75
A Related documents 79
B Conversion of metric units 81
Table B.1. Conversion between °C and °F temperature scales ........ 81
C Glossary 83