VÅNTEC-1 Detector User Manual Safety Issues
M88-E01072 1 - 3
Inside the VÅNTEC-1, voltages up to 15 KV DC
occur which are not accessible from the outside.
High voltages exist inside the detector and in
the cables with the label “HV” connecting the
detecting unit and the control rack. After turning
off the system, high voltages are still present.
They discharge over time. Wait a few minutes
before removing cables from the controller unit.
If one of these high-voltage components is dam-
aged, switch off the system immediately and
contact your local Bruker AXS Service Depart-
ment (in the U.S.A., 1-800-234-XRAY).
Sometimes complex D8 systems will be
supplied by several power supply lines. The
system and its components will be live until all
power lines connected to the system are
disconnected from the mains power supply.
The following warning symbols are displayed on
the detector. Strictly obey all instructions and
warning text printed on the labels attached to
the various parts of the equipment.
Wait 60 seconds after turning off HV power
before removing HV connectors!
X-ray window is Beryllium.
Any activity that scratches the window surface
can generate airborne Beryllium dust which can
cause lung disease if inhaled.
Beryllium metal in solid form, and as contained
in this product, presents no special health risks.
For additional information, reference MSDS.
The rating plate is also displayed on the detec-
tor.
Model #: 672-___________
100-240 VAC
50/60 Hz, 120 W
Fuse Rating: F, 3.15 A, 250 V
To Next Page
Loading...