Bruker VANTEC-1 User Manual

VÅNTEC-1 Detector User Manual Appendix C: Updating the Detector Controller Firmware
M88-E01072 C - 5
3. After typing the detector controller’s IP
address, hit Enter. The detector controller
prompts you for a user name and password.
Figure C.7 - Enter Password
4. Initially, the user name is user and the
password is the corresponding password
that was chosen in Section C.1. Enter the
username and password and click OK.
5. The detector controller menu appears in the
browser window.
Figure C.8 - Browsing the x86-based CPU board or PC
6. Select the Update System link from the
menu. The System Update page will appear
on the right side of the window.
Figure C.9 - System update package dialog

Bruker VANTEC-1 Specifications

General

Brand	Bruker
Model	VANTEC-1
Category	Security Sensors
Language	English