501 . . .
–
–
–
–
–
Section 5
23. Attach the maximum speed
label (if equipped) to a highly
visible location within the
vehicle.
24. Restow the tire sealant and
compressor kit in reverse order
as removal.
CAUTION
Storing the tire sealant and
compressor kit or other
equipment in the passenger's
compartment of the vehicle
could cause injury. In a sudden
stop or collision, loose
equipment could strike
someone. Store them in the
proper place.
25. Drive the vehicle 8 km (5
miles) to evenly distribute the
tire sealant.
26. Stop and park the vehicle in a
safe place.
27. Check the tire pressure after
driving to see if the puncture
has been sealed.
Check the tire pressure using
the air pressure gage on the air
compressor.
If the tire pressure has not dropped
more than 68 kPa (10 psi) below
the recommended inflation
pressure, inflate the tire up to the
standard operating pressure as
shown on the tire information
label.
See "Using the Air Compressor
Without Tire Sealant" later in this
section.
If the tire pressure drops more
than 68 kPa (10 psi) below the
recommended inflation pressure,
the vehicle should not be driven
farther. Damage to the tire is
severe and the tire cannot be
inflated or sealed using the tire
sealant and compressor kit.
Use a cloth to wipe up any tire
sealant on the sides of the vehicle,
tire and wheel.
Take the vehicle to the dealer as
soon as possible to have the
damaged tire inspected and
repaired.
AKENG40_CTS Page 501 Wednesday, July 23, 2008 11:47 AM
To Next Page
Loading...
Need help?
General
