Canon MAXIFY MB5160 - Default Network Settings

Default Network Settings
LAN Connection Defaults
Item Default
Change LAN Disable LAN
SSID BJNPSETUP
Communication mode Infrastructure
Wireless LAN security Disable
IP address (IPv4) Auto setup
IP address (IPv6) Auto setup
Set printer name* XXXXXXXXXXXX
Enable/disable IPv6 Enable
Enable/disable WSD Enable
Timeout setting 1 minute
Enable/disable Bonjour Enable
Service name Canon MB5100 series
LPR protocol setting Enable
Wired LAN DRX setting Enable
RAW protocol Enable
LLMNR Active
("XX" represents alphanumeric characters.)
* Default value depends on printer. To check value, use operation panel.
LAN settings
Direct Connection Defaults
Item Default
SSID (Identifier for direct connection) DIRECT-abXX-MB5100series *1
Password YYYYYYYYYY *2
Wireless LAN security WPA2-PSK (AES)
Direct connection device name ZZZZZZ-MB5100series *3
Connection request confirmation Displayed
353