SECTION 84 - BACKHOE 19
Unscrew and remove the nut (2) to disconnect the
backhoe lock (3).
Remove the snap ring (4), slide out the pin (5) and
with an hammer remove the pin (6) of the swing cyl-
inder.
Repeat the operation with both swing cylinders. Re-
move the snap ring (7).
Slide out the pin (8) and by means of an hammer re-
move the lower pin (9) from swing bracket.
Unscrew the screw (10).
Remove the upper pin (11) of the swing support.
Now it is possible to remove the backhoe assembly.
To Next Page
Loading...
