SECTION 21 - TRANSMISSION 269
SHIFT LEVER INPUT FAULT CODE F1
Perform input test
This test is used to verify operation of the shift lever
and its inputs.
In this mode driving is possible.
NOTE: the gear position indicators on the micro-
processor top cover are used to display the test in-
formation.
INPUT TEST REQUIREMENTS: with the powershift
lever in forward position and set to upshift (keep the
lever in this position during start-up), start the ma-
chine. The microprocessor shifts to the input test
mode. As shown in the table below placing the shift
lever in different positions in this mode illuminates its
respective LED (only 2 at the same time).
IMPORTANT: self test modes can only be started
WHILE POWERING UP (ignition on). Leaving the
self test mode is done by switching OFF the power
of the Microprocessor (ignition off).
*= Auto transmission only
**= Auto/Manual override
POWERSHIFT LEVER POSITIONS - WITH UP
AND DOWNSHIFT SELECTION
LED -
NUMBER
LED COLOUR - DISPLAYED = Ok
Neutral 2 RED
Neutral and upshift 3 RED
Neutral and downshift 1 RED
Forward 2 GREEN
Forward and upshift 3 GREEN
Forward and downshift 1 GREEN
Reverse 2 ORANGE
Reverse and upshift 3 ORANGE
Reverse and downshift 1 ORANGE
Operate disconnect button on loader lever 5 (*) (**) GREEN
Operate 4WD switch on instrument panel 6 (*) (**) GREEN
Foot brake test + 4WD 6 (**) GREEN
Foot brake test + 4WD 7 (*) RED
Transmission in automatic mode 7 (*) RED
Temperature and speed sensor: to test disconnect
lead on the sensor and short to ground
8RED
F28360
F
1234
12
Blinks Blinks
Blinks Slower
Blink
345678
NR T N
To Next Page
Loading...
