SECTION 25 - FRONT AXLES 25
PROBLEM CAUSE CORRECTION
Axle beam body bent Vehicle overloaded
Vehicle’s accident
Load bump
Replace axle beam body.
Worn out or pitted bearings Insufficient lubrication
Contaminated oil
Excessive use
Normal wear out
Replace bearings.
Use proper lubrication, fill up to right
level and replace at recommended
intervals.
Oil leakage form gaskets and
seals
Prolonged functioning at high
temperature of the oil
Oil gasket assembled incorrectly
Seal lip damaged
Contaminated oil
Replace the gasket and the
matching surface if damaged.
Use correct lubrication and replace
at recommended intervals.
Bent or broken half shaft Vehicle intensively operated or
overloaded
Replace.
Half shaft broken at wheel side Wheel support loose
Beam body bent
Replace.
Check that wheel support is not
worn out or wrongly adjusted.
To Next Page
Loading...
