Case 580SR+ - Page 542

50 SECTION 27 - REAR AXLE
Assembly
Remove the seal rings (2) from the axle beam (4).
NOTE: destructive operation for the seal rings (3).
Remove the bushing (3) from the axle shaft (4) only
if the wear conditions require it.
SWARNING
Be careful not to damage the bush seat.
Assemble the bush (3) on the axle beam with the
special tool 380002226 and a hammer.
Assemble the seal ring (2) on the axle beam with the
special tool 380002670 and a hammer.
Assemble the seal ring (2).
Insert the cardan shaft (1) into the axle shaft (4).
SWARNING
Be careful not to damage the seal ring.
3
2
2
F27281
2 3
F28029
F28048
2
1
4
F28049
www.maskinisten.net
Copyright ©